Continuing on with the near-final assembly of this garden lantern. I’m going to let the reader in on a little piece of information now that I have not been clear about. There are several reasons I have gone to the trouble of designing this lantern to be all-joinery (excepting the frames for the glass) – one is to to make it easy to fix, another is to make the piece so as to be maximally durable as it is intended to survive the outdoors. The reliance on pure joinery was a design challenge, and that was also part of the motivation. I like a challenge with every project. But there is yet another reason. I have designed this lantern to be readily demountable because my initial intent with it is to put it together and take it apart quite a few times. For fun? No, not exactly, though I will admit it is fun.
You see, the demountable nature of this piece lends itself well to explaining Japanese carpentry to others, and that’s what I am planning to do with the lantern for the first while – -talk about Japanese carpentry to various groups and build the lantern as I do it. Though I can show pictures and all and blather on for hours about a favorite subject of mine, I think I will really get the point across far more effectively if I assemble this piece right in front of their eyes, and at each step, explain the ‘how’ and the ‘why’. So, you might say I had a further underlying motive to my method, and I thought it would be well to be clear about that.
When I last left off I was assembling the upper tier of hijiki onto the pillow blocks and their sen. Two pieces were fitted at the conclusion of post 44, and so I’ll pick up where I left off, with the commencement of fitting the third hijiki:
As the last piece slides simultaneously onto four sen and the lap joint, there is a fair amount of surface friction between pieces – it’s a tight fit in other words. As it got closer, I needed to bring out a small block of MDF and a light hammer to seat the piece down. Here it’s beginning to engage in the three-way lap joint:
Fully seated, the last hijiki is really locked in there, simply by friction. In fact, in order to remove it I had to made up a special tool, using some Lignum Vitae blocks and some all-threaded rods. A bit of extra trouble, but this tool pulls the last hijiki back up without damaging or cracking the piece, or anything connected to it.
After the hijiki were reassembled onto the trimmed sen, then came time to put the dodai, (the sill pieces) into place:
I was worried that the look of the piece overall, with the painted end grain components would be somehow inferior to the unpainted – but I find I quite like it actually. I’m looking forward to seeing the lantern housing and roof in place to see the full visual effect of those parts with the painted end grain. I think it will be fine.
Bringing the sen story to a close, the central draw bars are now trimmed:
The resulting mark on the post tenon cheek:
I will later mark out the peg mortise completely, allowing for a slight draw bore, and drill and chop these small mortises out. Following that I will need to make up some more pegs, and then repeat the procedure with the tenons at the top of the posts which join to the keta.
Thanks for dropping by today. On to post 46